I was looking at the instructions in the Clymer manual and it calls for 4 different lubes to be used for the re-installation of the out-drive;
1.Marine lube ,PN 92-825407 for o-rings and housing
2.Grease for spline, PN 92-816391
3.Gimbal and U-joint lube, PN 92-828052A2
4.Cable lube, PN 92-13872A1
Are all these required or is there a more generic lube that works well in all these applications?
What's the biggest F-up that can be made during installation other than not having engine aligned?
1.Marine lube ,PN 92-825407 for o-rings and housing
2.Grease for spline, PN 92-816391
3.Gimbal and U-joint lube, PN 92-828052A2
4.Cable lube, PN 92-13872A1
Are all these required or is there a more generic lube that works well in all these applications?
What's the biggest F-up that can be made during installation other than not having engine aligned?
