Powerboat Forums at SpeedWake banner
1 - 8 of 8 Posts

·
Registered
Joined
·
482 Posts
Discussion Starter · #1 ·
I have two soft spots in the floor about 1'x1' each. where the rear bench seat mounts to the floor. i am thinking i should replace the whole floor. Opinions?

any tips on removing the floor, links to previous threads?

thanks in advance.
 

·
Registered
Joined
·
8,878 Posts
If it ain't broke...A co-worker did his a few years back and was looking at Pirelli rubber flooring and a few other alternative to carpet. He sealed everything up nice where'd you would have had to get water 2-3" deep to get over the edge of his floor. Not quite like a full liner in the cockpit, but easier clean up than carpet...just another idea...Good Luck with the project. Surprised to hear this. Remember your threads when you bought last year, looked like such a clean rig! Gotta be nice getting the gas leak fixed too! BE SAFE, Enjoy summer soon!!
 

·
Registered
Joined
·
482 Posts
Discussion Starter · #8 ·
RSCHAP1 said:
If it ain't broke...A co-worker did his a few years back and was looking at Pirelli rubber flooring and a few other alternative to carpet. He sealed everything up nice where'd you would have had to get water 2-3" deep to get over the edge of his floor. Not quite like a full liner in the cockpit, but easier clean up than carpet...just another idea...Good Luck with the project. Surprised to hear this. Remember your threads when you bought last year, looked like such a clean rig! Gotta be nice getting the gas leak fixed too! BE SAFE, Enjoy summer soon!!
Yeah, should have taken the time to have it serveyed.

Sombody's getin' F%$ked, I think its Daddy.

Live and learn, only place to go from here is forward.

enjoy your summer too. How's the weather over in Lowel, I work in Ionia, go through Lowel all the time. Nice little town.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top