Powerboat Forums at SpeedWake banner
Cancel

Morse Docking Lights

1265 Views 4 Replies 2 Participants Last post by  opie272, 
N
Ok here is a stupid a question....Do I have to replace the whole eyeball or does it come apart so I can replace the bulb? I tried to open it up, but it is either rusted or sealed. Any help would be great cause the new eyeball is $100 and I am not paying that much for something I only use 3 or 4 times a year.
Reply
Save
Like
1 - 5 of 5 Posts
O
If you have the same Morse lights as a Formula ?...then the ball comes out from the back side with 3 screws and the ball can be split so the bulb can be replaced separately.

I bought a BUNCH of replacement bulbs because when I was looking for replacements I had difficulty finding the right size.
Reply
Save
Like
N
Yeah mine are just like that. I've tried to seperate the two halves but they must be rusted together. I assume they are threaded and just screw together?
Reply
Save
Like
N
Yeah mine are just like that. I've tried to seperate the two halves but they must be rusted together. I assume they are threaded and just screw together?
Reply
Save
Like
O
my ball is "plastic" and has an oring seal if I remember right :rolleyes:
BUT it is a slip fit...no threads..on the ball
Reply
Save
Like
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Powerboat Forums at SpeedWake
A forum community dedicated to Powerboat owners and enthusiasts. Come join the discussion about performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
General Boating Discussions Technical Forum
Top