Thats an 1/8 inch toe in which is what I was told to run from Brad at BBLades his spes were 1/8 to 3/8 toe in. I run mine at 0 Id leave it there
Toe in or Toe out
So I'm researching how to set up my tie bar and I keep seeing everyone reference toe in or toe out. Is this from the leading edge or trailing edge of the drive?
Sorry for the stupid question, but this is my first twin engine boat. Right now I have it where the trailing edge of the drives are 1/8" wider than the leading edge. Is this toed out because the propshafts are wider, or is it toed in because the fronts of the drives are closer together??
btw my props are spinning out.
Thanks for the help
Frank
Sorry for the stupid question, but this is my first twin engine boat. Right now I have it where the trailing edge of the drives are 1/8" wider than the leading edge. Is this toed out because the propshafts are wider, or is it toed in because the fronts of the drives are closer together??
btw my props are spinning out.
Thanks for the help
Frank
1 - 3 of 3 Posts
Are your props spinning out or in?
1 - 3 of 3 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Powerboat Forums at SpeedWake
A forum community dedicated to Powerboat owners and enthusiasts. Come join the discussion about performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Recommended Communities
