Powerboat Forums at SpeedWake banner

1 - 10 of 10 Posts

·
Registered
Joined
·
4,109 Posts
Discussion Starter · #1 ·
couple questions, my wp pegs the gauge (30psi)sometimes so I want to install a relief valve. I dont think I have any obstructions, the temps also seem to go up to 180 when the wp is high so I hope to reduce the wp and lower the temps.

can someone walk me through what I need and where to tie it in,
 

·
Registered
Joined
·
19 Posts
Not Right said:
couple questions, my wp pegs the gauge (30psi)sometimes so I want to install a relief valve. I dont think I have any obstructions, the temps also seem to go up to 180 when the wp is high so I hope to reduce the wp and lower the temps.

can someone walk me through what I need and where to tie it in,
pete 180 temp on a efi is ok and as i remember the water pressure was always high i think it was the place is was tapped into... just my .2 cents....

stan
 
1 - 10 of 10 Posts
Top